MY17 MTS1200S DVT

D

desmoalb

New member
Hello! Im writing this post after some desperate visits in the workshop at ducati. The bike works perfectly until it goes to the 95-105°C that the problems begin! Bike runs great, revs perfectly. When you stop, and make that start, press the clutch insert the gear...bike stalls. Reving in neutral always when it's hot. After releasing the throttle it stalls. It's not a clutch issue since it happens also when you rev in neutral. The shop says, the bike is ok, after leaving the shop, stuck in traffic it starts to act like before. Anyone have had same issue? How did you solve? Thanks in advance!
P.S.
The bike has carried these services in the ducati workshop:
New sparkplugs,
Cleaning the Throttle body,
Injectors cleaning with ultrasonic,
New fuel filter,
The bike is stock.
 
Last edited:
I have had my 1260s Multi cut out when it has got very hot and I've been stuck in traffic, it is very frustrating.
I have seen write-ups from riders who have replaced the thermostat for a larger one which allows the coolant to flow more freely.
You could try removing the thermostat?
 
A possibility is a failing crank position sensor. I've had this issue on my 999S in the past.
 
Loz said:
A possibility is a failing crank position sensor. I've had this issue on my 999S in the past.
Click to expand...
Is it possible not to store any error on the ecu?cause the workshop says everything is running fine, there are not errors stored
 
desmoalb said:
Is it possible not to store any error on the ecu?cause the workshop says everything is running fine, there are not errors stored
Click to expand...
That was one of the "features" in my case - no error code stored :mad:
 
You must log in or register to reply here.
Back
Top Bottom