Did an oil change on my Speed Triple; bloody faff!
The filter is on the side so oil runs down the engine when it’s unscrewed, getting into all sorts.
When refilling, you put the oil in with bike on its side stand, filter off, until oil drips from filter housing. Then you fit the filter & add the rest of the oil. Then you run the bike which will immediately display an oil pressure warning, so with it still running, you unscrew the filter a little until oil seeps out. Turn off, torque the filter & the next time you start it the warning should be gone. ‘Burping’ apparently, to get rid of the unavoidable air lock.
Next you need to get the ODB tool out to clear the low pressure fault code. Then lastly, for the 3rd time, clean up the oil which by now is in all sorts of hard to get to places.
If done by the manual; it also requires removal of the gear change & a few other bits, but didn’t bother with that.
The old filter, last fitted by Triumph, was on so tight I had to heat it up & it still snapped my tool.
Bloody frustrating & shit design.